Navigation
Active forum topics
User login
Syndicate
qview measure
2006, April 6 - 11:23 — kkolb
I am using ISIS2 and qview to look at processed MOC cubes. When I try to use the qview measure tool, one end of the measuring line is always trapped in the upper left hand corner. Has anyone else experienced this and/or found a way to fix this?
- Login or register to post comments
- Printer-friendly version
ISIS Support Center
As much as I would like there to be lots of good traffic on this site, the topic of support for the ISIS software package is actually well done by the folks in Flagstaff. They have a very reasonable ISIS Support Center.
Ah, but you already know that, since I see you have already asked there. I certainly can't fault you for trying to cast a wide net.
No, I haven't ever had that problem, so I'm afraid that I can't help you on that.
However, if anyone can, you really should post to Kelly's thread on the ISIS Support Center. That's the right place for specific ISIS kinds of problems. Good luck.
problem solved
Looks like they did solve this problem on the ISIS help site. Follow the link Ross gave above. Apparently the num lock key was affecting things in this case.